How to Fix a Speed Queen Washer That Runs Without Water?

A Speed Queen washer that runs without water can be a frustrating issue to deal with, but it's a problem that can often be fixed with some basic troubleshooting. In this guide, we'll walk you through the steps to fix a Speed Queen washer that runs without water.

Here's what you'll need:

• Pliers
• Screwdriver
• Multimeter
• Replacement water inlet valve (if necessary)

Step 1: Check the water supply

The first thing to check when a Speed Queen washer is running without water is the water supply. Make sure that the water supply to the washer is turned on and that the hoses are not kinked or damaged.

Step 2: Inspect the water inlet valve

The water inlet valve controls the flow of water into the washer. Use a screwdriver to remove the screws that hold the top panel in place. Lift the panel off the washer and locate the water inlet valve. Inspect the valve for any signs of damage or wear.

Step 3: Test the water inlet valve

Use a multimeter to test the water inlet valve for continuity. Set the multimeter to the "ohms" setting and touch the probes to the two terminals on the valve. If the multimeter reads "0" or a low resistance, the valve is working properly. If the multimeter reads "infinity" or a high resistance, the valve is faulty and needs to be replaced.

Step 4: Replace the water inlet valve (if necessary)

If the water inlet valve is faulty, you will need to replace it. Purchase a replacement valve that matches the model number of your Speed Queen washer. Follow the manufacturer's instructions to install the new valve.

Step 5: Check the water pressure switch

The water pressure switch is responsible for regulating the amount of water that enters the washer. Use a screwdriver to remove the screws that hold the control panel in place. Lift the panel off the washer and locate the water pressure switch. Check the switch for any signs of damage or wear.

Step 6: Test the water pressure switch

Use a multimeter to test the water pressure switch for continuity. Set the multimeter to the "ohms" setting and touch the probes to the two terminals on the switch. If the multimeter reads "0" or a low resistance, the switch is working properly. If the multimeter reads "infinity" or a high resistance, the switch is faulty and needs to be replaced.

Step 7: Replace the water pressure switch (if necessary)

If the water pressure switch is faulty, you will need to replace it. Purchase a replacement switch that matches the model number of your Speed Queen washer. Follow the manufacturer's instructions to install the new switch.

Step 8: Reassemble the washer

Once you have replaced the water inlet valve or the water pressure switch (or both), reassemble the washer. Make sure that all screws are tightened and that the top and control panels are securely in place.

Step 9: Test the washer

Plug the washer back in and test it to ensure that it is working properly. The washer should now have water flowing into it during the appropriate cycles.

In conclusion, a Speed Queen washer that runs without water can be a frustrating issue, but it's a problem that can often be fixed with some basic troubleshooting. By following the steps outlined in this guide, you can get your Speed Queen washer back to working order in no time.