How to Fix a GE Top Load Washer That is Stuck on the Sending Cycle?
A GE top load washer that is stuck on the sending/fill cycle can be frustrating to deal with, especially if you have a full load of laundry waiting to be washed. Fortunately, this is a common issue that can be fixed with a little bit of troubleshooting. In this guide, we'll walk you through the steps to fix a GE top load washer that is stuck on the sending/fill cycle.
Here's what you'll need:
- Pliers
- Screwdriver
- Multimeter
- Replacement water inlet valve (if necessary)
Step 1: Unplug the washer
Before you begin any repairs, it's important to unplug the washer from the power source to prevent electrical shock.
Step 2: Check the water supply
Make sure that the water supply to the washer is turned on and that the hoses are not kinked or damaged.
Step 3: Inspect the water inlet valve
The water inlet valve controls the flow of water into the washer. Use a screwdriver to remove the screws that hold the top panel in place. Lift the panel off the washer and locate the water inlet valve. Inspect the valve for any signs of damage or wear.
Step 4: Test the water inlet valve
Use a multimeter to test the water inlet valve for continuity. Set the multimeter to the "ohms" setting and touch the probes to the two terminals on the valve. If the multimeter reads "0" or a low resistance, the valve is working properly. If the multimeter reads "infinity" or a high resistance, the valve is faulty and needs to be replaced.
Step 5: Replace the water inlet valve (if necessary)
If the water inlet valve is faulty, you will need to replace it. Purchase a replacement valve that matches the model number of your GE top load washer. Follow the manufacturer's instructions to install the new valve.
Step 6: Reassemble the washer
Once you have replaced the water inlet valve or determined that it is working properly, reassemble the washer. Make sure that all screws are tightened and that the top panel is securely in place.
Step 7: Test the washer
Plug the washer back in and test it to ensure that it is working properly. The washer should now move past the sending/fill cycle and continue with the wash cycle as intended.
In conclusion, a GE top load washer that is stuck on the sending/fill cycle can be a frustrating issue, but it is one that can be easily fixed with the right tools and some basic troubleshooting. By following the steps outlined in this guide, you can get your GE top load washer back to working order in no time.
