E01 and E103 Error Codes on a 10-Year-Old Maytag Front Load Washer

If you have a 10-year-old Maytag front load washer that's showing error codes E01 and E103, don't worry! These error codes indicate a problem with the washer's water level sensor, and can be fixed with some troubleshooting. In this guide, we'll walk you through the steps to fix the issue.

Step 1: Check the Water Supply

The first thing you should do is check the water supply to the washer. Make sure the water supply valves are fully open and the hoses are not kinked or damaged. If the water supply is not the problem, move on to the next step.

Step 2: Clean the Drain Pump Filter

The E01 and E103 error codes can also be caused by a clogged drain pump filter. To clean the filter, locate the small door on the front of the washer near the bottom. Open the door and use a small brush or cloth to remove any debris from the filter. Once the filter is clean, close the door and try running the washer again.

Step 3: Replace the Water Level Sensor

If the water supply and drain pump filter are not the issue, then the problem may be with the water level sensor itself. You mentioned that you've already replaced the sensor, but if the problem persists, it may be a faulty replacement part. Consider replacing the water level sensor with a new one from a trusted manufacturer.

Step 4: Contact a Professional

If none of the above steps work, it's time to call in a professional. Contact Maytag or a trusted appliance repair service to diagnose and fix the issue with your washer.

In conclusion, the E01 and E103 error codes on a 10-year-old Maytag front load washer can be fixed with some troubleshooting. Check the water supply, clean the drain pump filter, replace the water level sensor, or contact a professional for assistance. With a little effort, you can get your washer back to working order in no time.

Additional Tips to Keep Your Maytag Front Load Washer Running Smoothly

In addition to troubleshooting the E01 and E103 error codes, there are several steps you can take to keep your Maytag front load washer running smoothly. Here are a few tips:

1. Use the Right Detergent: Maytag recommends using HE (high-efficiency) detergent in their front load washers. This type of detergent is specially formulated to work with the washer's low water levels and gentle tumbling action.
2. Clean the Washer Regularly: Over time, dirt, soap scum, and other debris can build up inside your washer, leading to unpleasant odors and reduced performance. To keep your washer clean, run a cleaning cycle once a month using a washing machine cleaner or a mixture of vinegar and baking soda.
3. Don't Overload the Washer: It's tempting to stuff as many clothes as possible into the washer to save time, but this can put a strain on the machine's motor and other components. Follow the manufacturer's guidelines for load size to avoid damaging your washer.
4. Check the Door Seal: The rubber door seal on your Maytag front load washer can become dirty or damaged over time, leading to leaks and other issues. Check the seal regularly and clean it with a mild detergent if necessary.

By following these tips and troubleshooting any issues that arise, you can keep your 10-year-old Maytag front load washer running smoothly for years to come.